Test / calibration stands
We carry out tests and calibrations of flowmeters in a range from
3 l/min to 1,200 m³/h at our officially approved test stations.Prüf- / Kalibrierstände.
Test station “Water test bench”
For calibration of vortex meters and vortex meter measuring sections, orifices, nozzles, venturi nozzles, complete differential pressure measuring sections up to DN150
- Water
- Calibration piston 100, 500 and 3000 l
- Flow rate max. 450 m³/h
- Measurement uncertainty +/- 0.03% of measured value
- max. 5bar
Two-way pipe loop” test station
For calibration of vortex meters and vortex meter measuring sections, mass flow meters, orifice plates, nozzles, venturi nozzles, complete differential pressure measuring sections up to DN400
- hydrocarbon
- 2.8 mPa-s
- DN80 – DN400
- 12 m³/h to 1.200 m³/h
- Measurement uncertainty +/- 0.06% of measured value
State-approved testing laboratory KRP/2
Testing laboratory for calibration and recalibration of heat meters, vortex meters, ultrasonic meters, orifices, venturi nozzles and pipes
- Water
- DN15 – DN150
- 50°C – 55°C (test bench temperature)
- Flow rate max. 420 m³/h